Shifter bell plate Nissan Patrol
(w/o VAT:57.07 €)
(w/o VAT:3.63 €)
Clutch fork dust boot for Nissan Patrol Y61 ZD30
(w/o VAT:21.44 €)
(w/o VAT:1.62 €)
Increased area for the front driveshaft passage.
Can be used to replace the original axle. No modifications are necessary during assembly.
The kit includes mounting screws
(w/o VAT:312.42 €)
TCU controller located in the armrest.
The bundle includes all plugs, display, program knob and instructions for connection.
(w/o VAT:458.15 €)
(w/o VAT:670.52 €)
Gearbox spacer plate Nissan Patrol Y60 Y61
Plate thickness 8mm
Galvanized
If the vehicle is raised above the factory height, the deviation of the rear gimbal angle will cause vibrations. By fitting spacer plates between the gearbox mount and the chassis, this angle can be restored to or near the original angle so that the "jounce" of the gimbal is eliminated.
Longer transmission mount bolts are required when using more than 2 plates.
(w/o VAT:18.73 €)
(w/o VAT:9.36 €/db)
Functional gear selector from RC
Is your body lift or transfer case drop giving your Jeep TJ shifting issues? Then check out Rough Country's Jeep TJ straight shaft lower gear selector. This innovative little product fixes a common issue with Manual Jeep TJ's that pop out of gear or do not properly engage 2nd, 4th, and reverse gears on Jeeps outfitted with either a transfer case drop kit or up to 2" body lifts. This product extends the height of the shifter 0,5" over stock height. Factory TJ gear selectors have a 1,25" offset bend towards the rear of the Jeep, while our design features a straight shaft for optimal height and clearance. Best of all, this item is easy to install! The selector replaces the factory part and mounts perfectly with the existing shifter. No cutting, welding or other round-about adapters to fool with.
- Easy bolt-on installation
- Fixes the common problem of manual tranmission TJs popping out or not engaging in 2nd, 4th and reverse gears
- Lower gear selector is 0,5" longer than stock
- Moves the base of the shifter 1,25" forward
- Can be used in place of weld on extensions that usually come with a body lift kit
Notes:
- Fits manual transmission models ONLY
- Fits AX-5 and AX-15 transmission models ONLY
- Does NOT fit NV3550 transmission models
- Fits models with up to a 2" body lift kit
- Fits models with up to a 1,5" transfer case drop without a body lift kit
(w/o VAT:225.94 €)
(w/o VAT:698.44 €)